云外天
积分:7468 级别:论坛总版主 头衔: 来自:辽宁铁岭 | | | | re:
R1 = 8.2K
R2 = 2.2K
R3 = 680R
R4 = 1K
R5 = 82K
R6 = 0.18R/5W
C1 = 470p
C2 = 100nF-63V
C3 = 100nF-63V
C4 = 100uF-63V
C5 = 10KuF-60V
D1-D6 = 6.6A
Q1 = MJ3001 (Darligton)
IC1 = UA723D
Specifications:
Overload protected
Sshort-circuit stable
Output current: max. 3A
Output ripple voltage: 0.5mV
Output voltage: adjustable from 3 to 30V, stabilized
Input voltage: 9 to 30V AC (depending on the desired output voltage)
Assembling into a housing:
Depending on the transformer used, one may chose one of two housings
If a metal housing is used, it must be earthed for security purposes.
Make sure the cooling body does not touch the housing. This might cause a short circuit.
When mounting a toroidal transformer, it must be seen to that the fixation bolt does not touch the cover. This might cause the burning of the transformer
If the circuit is to be integrated into another housing, it must be provided with ventilation holes (one may make these holes oneself), necessary for the release of the heat developed.
Notes :
Connect a voltage meter to the points ‘GND’ and ‘+OUT’ and adjust ‘RV1’ until the desired output voltage is reached.
Apply some thermo-conducting pasta to the bottom side of the transistor and mount it on the heatsink.
If you need 3-8 volt then R2 will be 5.6K
If you need more than 8 volts then the R2 will be 2.2K
Suitable transformer 30vAC at 120VA
有附件:[6K]
-- 云外天的淘宝店
| | 编辑帖子 删除帖子 IP:[124.95.95.*] 发表时间:2013年02月13日 02:16:29 |
|